Levelone GNS-2000 Manual do Utilizador descarregar pdf (Página 7)

HDD Remove

1. Make sure the NAS Server is power off.

2. Open rear cover of NAS Server.

3. Pull out the HDD till HDD connector release then the HDD

can slide out of slot.

System Installation

Boot up

1. Connect the network cable to LAN port on the rear of NAS

Server. Connect the others end to your hub or switch.

2. Connect the supplied power adapter to a power outlet and

plug the power cord into NAS 

rear panel.

3. Power on

ver

real panel. Press it once to power on the NAS.

4. The NAS Server self-test

The NAS Server will run a brief self-test. During the self-

test, all of NAS Serhing.

5. Booting up

When the self-test is complete, boot up will start. The

Ready LED will blink continuously, and the LAN LED will

blink occasionally. Boot up should take approximately 1-3

minutes.

6. Boot up completed

1 2 3 4 5 6 7 8 9 10 11 12 ... 122 123

Sem comentários

Levelone GNS-2000 Manual do Utilizador Página 7