Levelone GNS-2000 Manual do Utilizador descarregar pdf (Página 5)

HDD Install/Remove

The NAS Server supports two 3.5-inch Serial-ATA (SATA) hard

drives and does not support low profile or half high hard drive.

HDD Install

1. Make sure the NAS Server is powered off.

2. Open rear cover of NAS Server.

3. Make sure your hard drive is SATA interface and make

sure you back up all pre-existing data before use it on

NAS Server.

4. To install Disk 1 that located on left side (rear view), make

sure HDD top face to left and connector side in front then

slide the HDD into slot.

1 2 3 4 5 6 7 8 9 10 ... 122 123

Sem comentários

Levelone GNS-2000 Manual do Utilizador Página 5