Levelone WPC-0301 Manual do Utilizador

LevelOne User Manual Ver. 6.0.0-0712 WNC-0301 WPC-0301 11g Wireless LAN Adapter i

Check the installation The LEDs of the Wireless LAN Adapter are clearly visible and the status of the network link can be seen instantly: 1. Once t

Software Installation This section will lead you to install the driver and utility of the Wireless LAN Adapter. Windows 2000/XP/Vista Utility Instal

3. Follow the Install Shield Wizard Instructions. Click “Next” to continue and finish it. The installation program will help you to setup the Wire

Windows Vista Wireless Utility Setting Link Information This is the default screen after launching the Utility program. Status: Shows the associate

Configuration This screen is where you set the basic wireless settings for the Wireless LAN Adapter. Profile Name: The default name is the same a

Authentication: The following options are available: Open System, Shared key, WPA-PSK, WPA2-PSK, WPA EAP-TLS and WPA2 EPA-TLS. Select Open System, Sh

Site Survey This screen allows the user to scan for available wireless networks (wireless clients and Access Points). It also allows the user to esta

Profile Profile –The user can create and manage the created profiles for home, work or public areas. By double-clicking on one of the created profile,

About This screen displays information about the 11g Wireless LAN Adapter, such as the Driver and Utility version. When a new version of the utility

Windows XP/2000 Wireless Utility Setting Link Information The default page is as below after launching the Utility program. Status: Shows the assoc

Safety FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interferenc

Data Rate: Shows the statistics of data transfer, and the calculation is based on the number of packets transmitted and received. Configuration This

WARNING: Country domain can't be choosing by end-user, because the incorrect region may be in violation of applicable laws. Power Mode: There a

Advanced This screen is where you configure the Security settings for the 11g Wireless LAN Adapter. Auth Mode: Select the authentication type from

Open System / Shared Key WEP Key 1~4: choose the encryption way, either in HEX or ASCII formats, and enter the password in the blank space.

Key Length: select 64 or 128 bits as the length of the keys. If you select 64bit in Hex format, you must type 10 values in the following range (0~F, h

WPA / WPA2

If WPA or WPA2 is selected, the above screen is shown. Please select the encryption type from drop down menu and press Configuration button to config

created profile, the setting will adjust to the specific setting such as SSID, channel, and WEP as saved by that particular profile. Add: Adds a profi

About This screen displays information about the 11g Wireless LAN Adapter, such as the Driver and Utility version. Users are able to identify by vers

25 Technical Specifications General Radio Technology IEEE 802.11b Direct Sequence Spread Spectrum (DSSS) IEEE 802.11g Orthogonal Frequency Division M

Table of Content TABLE OF CONTENT...V I

Introduction Congratulations on your purchase of LevelOne11g Wireless LAN Adapter. This manual helps to get familiar with the LevelOne 11g Wireless L

Unpacking and Setup This chapter provides the package contents and setup information for the 11g Wireless LAN Adapter. Features z Works with both

Setup The setup of the Wireless LAN Adapter can be performed using the following steps: z Visually inspect the CardBus/PCI Adapter and make sure tha

Hardware Installation Installation Procedure for PCI Please shut down your Computer and install the Wireless PCI Card BEFORE installs the supplied s

z The Windows "New Hardware" wizard will then prompt. Please click Cancel 6

Installation Procedure for CardBus You should install the supplied software BEFORE inserting the Wireless Adapter when using Windows 2000 or XP. When