LevelOne GSW-2600TXM Manual do Utilizador descarregar pdf (Página 123)

123

Flow Control Disabled Used to enable or disable flow control. Flow control can

eliminate frame loss by “blocking” traffic from end

stations or segments connected directly to the switch

when its buffers fill. When enabled, back pressure is

used for half-duplex and IEEE 802.3x for full-duplex.

Note that flow control should not be used if a port is

connected to a hub. For the Gigabit modules the options

for flow control are set out below:

Switch Link Partner Flow Control

Rcv/BothWay SendOnly Switch can only receive

pause frames, link partner

can only send pause

frames.

Rcv/BothWay BothWay Both switch and link partner

can send and receive

pause frames.

Jack Type Shows the jack type for each port.

Ports 1-11,13,23: RJ-45

Ports 12,24: FIBER or RJ-45

Ports 25-26: RJ-45, FIBER

3.6.2.2.Using a Port Mirror for Analysis

You can mirror traffic from any source port to a target port for real-time analysis. You

can then attach a logic analyzer or RMON probe to the target port and study the traffic

crossing the source port in a completely unobtrusive manner. When mirroring port traffic,

note that the target port must be included in the same VLAN as the source port. (See

“VLAN Table Configuration” on chapter 3.)

You can use the Mirror Configuration screen to mirror one or more ports to the monitor

port as shown below.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 199 200

Sem comentários

LevelOne GSW-2600TXM Manual do Utilizador Página 123