LevelOne POI-3002 Guia de Instalação

POI-2001 & POS-1001 Gigabit PoE Injector & Splitter POI-2002 & POS-1002 PoE Injector & Splitter POI-3004 Gigabit PoE Injector

Installation Steps  Connect AC Power cord to the PoE Injector, and "Power" LED will light up.  Schließen Sie das Netzkabel an den

 Connect "Data/In" port of Injector to Non PoE switch via Cat.5e/6/7 cable, and set the correct voltage (5V, 9V or 12V) by adjustable

 Conecte a porta "Data/In" (Dados/Entrada) do injector ao switch não PoE através de um cabo Cat.5e/6/7 e defina a voltagem correcta (5V

 Συνδέστε την “Power + Data” θύρα του Splitter και την “P+D/out” θύρα του Injector με ένα Ethernet καλώδιο, και σιγουρευτείτε πως το “Power” LED

(gegevensuitgang) van de splitter aan op de RJ45-poort van het netwerkapparaat. (Zorg dat u de juiste verwisselbare pen kiest voor het aandrijven

 Check whether the network device is on. If not, please make sure that power is on for Injector and Splitter, and all cables are connected corre

Connection Diagram: